mortalic to 3DPrintingEnglish · 23 days agoAny ideas why the top roof warped like it did?imagemessage-square15linkfedilinkarrow-up167arrow-down11file-text
arrow-up166arrow-down1imageAny ideas why the top roof warped like it did?mortalic to 3DPrintingEnglish · 23 days agomessage-square15linkfedilinkfile-text
minus-squareMilitiaslinkfedilinkEnglisharrow-up7·23 days agoNot sure why it would warp there, perhaps infill percentage is too high? If you don’t need the layer lines to be in a specific orientation I’d consider rotating the model back 90° for the reprint, hopefully that should avoid any warping.
minus-squaremortalicOPlinkfedilinkEnglisharrow-up1·22 days agoThat does seem to be a good suggestion. I think I’ll do that.
Not sure why it would warp there, perhaps infill percentage is too high?
If you don’t need the layer lines to be in a specific orientation I’d consider rotating the model back 90° for the reprint, hopefully that should avoid any warping.
deleted by creator
That does seem to be a good suggestion. I think I’ll do that.