Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.
I know I have terrible eyesight, but it seems like I opened blind or dyslexic community. Why only few people noticed
Must be your eyesight, my friend. Looks normal to me…
They didn’t have to cut shit.
Which was discovered AS RESULT of cutting open.
You are quite spammy, aren’t you?
No, the shaft was not uncovered as a result of cutting the thing open. They were able to reach the screw-head with a regular screw-driver, just not turn it. Says right there in the post.
Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.
I’ll reply with your quote:
This was NEVER about access to the screw.
Thanks for stating obvious. I’ve never said that it was about access.
Since its not about access then they never had to break anything for any reason besides their own impatience, plain and simple.
OP could stick A screwdriver, but to insert correct screwdriver OP had to see that screwhead is different. Or manufacturer had to write it in fucking manual.