- cross-posted to:
- [email protected]
- cross-posted to:
- [email protected]
If you use the right ink, the right plastic keycaps made for mechanical keyboards, and the right settings on your laser, you can effectively dye-sublimate any design you want.
If you use the right ink, the right plastic keycaps made for mechanical keyboards, and the right settings on your laser, you can effectively dye-sublimate any design you want.
I’m using Cricut Infusible Ink markers. They were pretty much made for this, using heat to dye polyester-based materials, like PBT. I just have a 5w diode laser, and I do it “low and slow,” 2% power and 45mm/minute. Black and blue still work best, but the red (pink) and green can be nice too.
I have done two entire keyboards worth. The gray DSA i did in black are holding up great, but the legends went on wonky because I hadn’t refined my workflow. The next batch I did was on this same type of white XDA but while alignment was vastly improved, the ink didn’t go on as well. The only thing I did differently with these two was make sure to clean the caps with IPA first.