I’ve got an antique lamp that needs a new switch knob, but then scope-creep happened and now I want to “smartify” it. I started off thinking that, since it has a metal body, I’d install a capacitive touch switch, but now it’s escalated to wanting to put an ESP8266 or ESP32 in it to handle the capacitive sensing, Home Assistant connectivity/control, and maybe even switching to some kind of low-voltage RGBW LED instead of a 120VAC Edison-base bulb (especially since I suspect I’d need some kind of antenna sticking out the top, since the metal lamp body would presumably otherwise block the ESP32’s signal).
The lamp, BTW:
(Apparently it’s a Genie lamp by Laurel Lamp Company, in case anybody cares. Also, the lamp shown is the same model, but it’s not my picture.)
I’m aware that the “easy” way would probably be to just screw a smart light bulb into the socket and wiring I already have, but (a) I’m picky about both avoiding “clouds” and using FOSS firmware, and I don’t feel like sorting through the junk on Amazon to figure out which ones can be flashed with ESPHome, and more practically (b) that wouldn’t let me turn it on and off just by touching the lamp body, which is what sent me down this rabbit-hole in the first place.
Anyway, I know this sort of thing can be done, but I’m not completely sure how. I know I could figure it out myself eventually, but I figured it couldn’t hurt to ask for advice in case somebody happens to be able to rattle off part numbers for the whole BOM off the top of their head, or knows exactly the right ESPHome howto to point me towards, or something like that. Any advice is welcome!
(In case it’s relevant: my level of experience is that I programmed an Arduino to run neopixels (WS2812 RGB addressable LEDs) once, I’ve flashed ESPHome on some Sonoff S31 smart switches, and I’m a software engineer by trade but have never worked on anything IoT related professionally.)
It’s more or less a consumer version of their RA2 system, which is its own protocol. The gateway interacts with the whole system using commands issued over telnet though, so you actually have a command line for operating and configuring it. It integrates with a bunch of closed systems, and it integrates right into Home Assistant with a first-party HA integration.
It’s not like you can inspect the source code for their firmware push up pull requests on GitHub, so I’m this aspect, yes, it is proprietary. However, with tools like Home Assistant, which is something you probably should be using, this becomes much less of a concern, in my opinion. It’s robust, high-quality, and is commonplace, so you can get bits and pieces at Home Depot.
If you’re interested in something that will work with mesh networks and you aren’t interested in running software like Home Assistant, you should look for Z-Wave or Zigbee hardware. Read reviews though; I’ve had a lot of mixed experiences with hardware, even from “trusted” vendors.