OpenFlexture Microscope is an open-source, 3D-printed microscope based on Raspberry Pi 4 SBC and Camera Module v2 - CNX Software

www.cnx-software.com

OpenFlexture Microscope is an open-source, 3D-printed microscope based on Raspberry Pi 4 SBC and Camera Module v2 - CNX Software

www.cnx-software.com

Alphane Moon to

Raspberry [email protected]English • 6 days ago

The OpenFlexture Microscope is a DIY, open-source, 3D-printed microscope built around the Raspberry Pi 4, a Raspberry Pi Camera Module v2, and a choice of

You must log in or register to comment.

Chat

Raspberry [email protected]

[email protected]

Create a post

You are not logged in. However you can subscribe from another Fediverse account, for example Lemmy or Mastodon. To do this, paste the following into the search field of your instance: [email protected]

Welcome to the programming.dev Raspberry Pi community!

Raspberry Pi is a series of small single-board computers. It is widely used in many areas because of its low cost, modularity, and open design. It is typically used by computer and electronic hobbyists.

Rules

Members of this community are expected to exhibit mature and respectful behavior.

Those who fail to uphold these standards may find their posts or comments removed, with repeat offenders potentially facing a permanent ban.

Please keep discussions in English so that they can be appropriately moderated.