@[email protected]M to 3DPrintingEnglish • 6 months agoCommon printing questionslemm.eeimagemessage-square84fedilinkarrow-up1379arrow-down136
arrow-up1343arrow-down1imageCommon printing questionslemm.ee@[email protected]M to 3DPrintingEnglish • 6 months agomessage-square84fedilink
minus-square@lefixxxlinkEnglish2•6 months agoLower layer height will make the steps smaller. In orca slicer you can use adaptive layer height to decrease layer height just on the top of the dome. Choosing different printing orientation can be a solution.
Lower layer height will make the steps smaller. In orca slicer you can use adaptive layer height to decrease layer height just on the top of the dome.
Choosing different printing orientation can be a solution.