• @Cort
    link
    23 months ago

    I just can’t feel that point where the clutch engages/disengages so I keep stalling at take off or grinding the gears when shifting. Haven’t tried again in a decade.

    • @[email protected]
      link
      fedilink
      English
      23 months ago

      You’re supposed to push the clutch fully to the floor when shifting. You should never grind gears unless you’re about to money shift or something.

      • @Cort
        link
        23 months ago

        That could be the problem. I was told to shift when I felt the clutch take the power off the engine, and then give it a little gas when I feel the gears remesh. It was also on a 30 year old Peterbilt 5/10 speed hi/lo truck with everything worn out, so probably not the best thing to learn on

        • @[email protected]
          link
          fedilink
          13 months ago

          Yeah no, you’re better off learning on a car. And just know that what you will do at the beginning is different from what experienced drivers do, as they’ll have developed a “feeling” for the car that you don’t have yet, so just do it by the book.

        • @[email protected]
          link
          fedilink
          English
          1
          edit-2
          3 months ago

          Learning on a transmission with >6 speeds is hard mode, they do take a little more thinking with the gear pattern than in a car. Synchro versions are not that hard if you’re used to a regular manual but adding another thing to learn is not ideal when starting out. If it was a non-synchro variant then good luck getting someone to pick that up without a few solid hours of learning time.

          If you were being taught by someone used to heavy trucks it makes sense why they didn’t tell you to push the pedal right in - on many (all?) non synchro transmissions pushing the clutch all the way in brakes the input shaft and if you’re moving you then have to resynchronise it with the gear speed in order to get into gear.

          Note you don’t actually have to push the clutch in all the way in a car either, all that really matters is getting it past the point where the clutch is fully disengaged. After all the clutch plate is either touching the flywheel to some degree or it’s not touching, once it stops making contact pushing it further away doesn’t make a difference. When first starting out though it’s easier to just push the pedal all the way in - save thinking about finer details until you’re comfortable with the basics.