Hi everyone,

As in the title, I would start to learn how to design models for 3D printing and the basics about 3D printing, but I’m a total noob.

Do you have any suggestions about where to start?

Thanks everybody

  • @Zomg
    3•2 hours ago

    For very basic model making, try tinkercad, it runs in your browser and gives you some basic controls to make objects.

    Knowing what printer you have might allow others to give you advice, some printers behave differently than others in terms of hardware and system software.

    Good luck

    • @[email protected]OP
      3•2 hours ago

      Thanks for the suggestion. I’ll look into Tinkercad for starting.

      Actually I don’t have any printer and I really don’t know where to start looking at. Thanks again