My wife turned on the wall switch and the pendant light over our dining room table went out. The fuse outside didn’t blow—none of them needed to be reset. I checked for power in the light’s hanging cord, but nothing. I pulled the wall switch to check for power and nothing there either. Thoughts?
Start looking for tripped GFCI outlets.
If there is no power to the switch and the breaker didn’t trip there is likely a switch with GFCI on the mix.
Another possibility could be a bad breaker (assuming you don’t have actual fuses), check this by flipping the breaker off and back on. This could also help to identify other lights/outlets on the circuit. If there is a wiring problem, knowing what other devices are on the circuit could help you track the problem.
While not impossible, it is unlikely that a wire has been severed. It is possible that a wire came loose at another outlet or fixture in the circuit.
If there was a true short, the breaker would be tripped out fuse blown and it would continue to trip.
Problem exists between breaker and wall switch.
I always encourage people to do an audit of what is on every breaker when they get a new home (and make notes). It takes a little while, but when something like this happens, you know exactly where to look. It’s harder to diagnose if you don’t know what breaker the fixture is on.
Agree on the GFCI advice. I had that happen - the GFCI outside tripped and took out half of the lights in my kitchen. Whoever wired them put them electrically downstream of the GFCI. Took me days to figure out what was going on, because it didn’t occur to me that the outside GFCI would be protecting my kitchen lights. And I wasn’t trying to use the outside outlet for anything, so I didn’t notice it was out.
I hate that. Some genius was either too cheap or too lazy to wire it correctly and just tied it into an unrelated circuit.
That is the only thing that makes sense. I may have to just check EVERY GFCI in the whole house. I wouldn’t put it past the builder to do something crazy with the wiring….