Having recently moved in to a new place, I needed to unclog out both bathroom sink drains. This house was built in the 50’s and the previous owner used draino liberally, so both drain tail pipes snapped like twigs at the threads when I went to remove the trap. I tried replacing only the damaged parts, but ultimately, nothing was salvageable, as each part I replaced led to another catastrophically failing.

The guest bathroom plumbing wasn’t too bad, as the vanity is spacious and things were at least installed correctly despite the damage. The en suite, however, has a cramped vanity, is too tiny to lay down in, and whoever did the plumbing directly abs-welded the <1" wall stub to a DWV elbow instead of using a slip joint. I had to take a hacksaw blade and gently floss the pipe between the wall and the joint, taking ~45 minutes and only having enough room to use my fingers to grab the blade

The plumbing is now done correctly, uses the right parts, and will never see draino again as long as I live here.

  • oshu
    link
    519 hours ago

    You have to buy Draino continuosly but you only have to buy a good plunger once

    • drailOP
      link
      fedilink
      15 hours ago

      Too true. Snaking a drain every once in a blue moon is so much easier than dealing with draino damage.