I recently bought a Kreg ACS Project Table combo kit. I did all the proper setup techniques. I cut my zero clearance line in the table. Installed all the measurement strips. All that setup, done by the book and YouTube videos.
I lined up all my stock against the bench dogs and started ripping…
After checking all the boards, they’re not all cut perfectly square! I thought the concept of this system was it was near impossible to get misaligned cuts? Anybody else have this issue? Help please! Haha
Check if your saw blade is actually 90° to the track - most track saws have a small adjustment screw for the 90° stop that can drift over time, and it’s someting that’s easy to miss during initial setup.