Since, my doctor recommend that I put more fiber in my diet- I decided to comply.

So… in a few hours, I will be running a few OS2 runs across my house, with 10G LR SFP+ modules.

Both runs will be from my rack to the office. One run will be dedicated for the incoming WAN connection (Coupled with the existing fiber that… I don’t want to re terminate). The other, will be replacing the 10G copper run already in place, to save 10 or 20w of energy.

This, was sparked due to a 10GBase-T module overheating, and becoming very intermittent earlier this week causing a bunch of issues. After replacing the module, links came back up and started working normally… but… yea, I need to replace the 10G copper links.

With only twinax and fiber 10G links plugged into my 8-port aggregation switch, it is only pulling around 5 watts, which is outstanding, given a single 10GBase-T module uses more then that.

Edit,

Also, I ordered the wrong modules. BUT… the hard part of running the fiber is done!

  • @TheInsane42
    link
    English
    11 year ago

    The Netgear 324 I have is picky (seems to support only SFP, not SFP+, the 724 was gifted and accepts the 1.25G UTP module. I also have a Cisco 3560 24P with 2 sfp ports. No clue yet if that works correctly and how much power it’ll use, but I can test with a short fiber cable I have (when it’s not damaged to much) Also, no clue yet how I’d route the fiber trough the house, 4 floors up, 1 across and then 1 down. (about 15-20m) I have cat6 throughout the house, but that’s a tad less fragile.