@lukenamopM to Strange Planet by Nathan W. PyleEnglish • 1 year agologicalimagemessage-square467arrow-up12.98Karrow-down192
arrow-up12.89Karrow-down1imagelogical@lukenamopM to Strange Planet by Nathan W. PyleEnglish • 1 year agomessage-square467
minus-square@curiousPJlinkEnglish1•edit-21 year agoExcept well… when it comes to aerospace hardware. It’s all inch threads. There are no metric hardware (bolts and nuts) in planes. They (countries other than the US) literally have to have inch hardware and tools to service aircraft. While the base inch unit is derived from metric. Actual industry standards like https://www.sae.org/standards/content/as8879/ are not ‘metric’ by any means.
minus-square@[email protected]linkfedilinkEnglish1•1 year agoAgain, all standards ( gauge blocks and the like) are all calibrated from a metric standard. This is due to how Carl Evard Johansson made them. You might be using the SAE standard, but that is referenced to the SI standard which is what metric became.
minus-square@curiousPJlinkEnglish0•1 year agoYou’re confusing Metrology Calibrations/Traceability with standards for industry quality. And just because the inch unit is derived from a SI unit it doesn’t mean an M12x1.25 bolt will be a functional replacement in a 1/2-20 thread. There’s more to the inch/metric debate than your focus on academia…
Except well… when it comes to aerospace hardware. It’s all inch threads. There are no metric hardware (bolts and nuts) in planes. They (countries other than the US) literally have to have inch hardware and tools to service aircraft.
While the base inch unit is derived from metric. Actual industry standards like https://www.sae.org/standards/content/as8879/ are not ‘metric’ by any means.
Again, all standards ( gauge blocks and the like) are all calibrated from a metric standard.
This is due to how Carl Evard Johansson made them.
You might be using the SAE standard, but that is referenced to the SI standard which is what metric became.
You’re confusing Metrology Calibrations/Traceability with standards for industry quality.
And just because the inch unit is derived from a SI unit it doesn’t mean an M12x1.25 bolt will be a functional replacement in a 1/2-20 thread.
There’s more to the inch/metric debate than your focus on academia…