The kit was $17 on Amazon. You can order direct from Cerakote too, but you have to pay like $6.99 shipping. Kit was worth it. It was not difficult at all! Might have been a little easier for me because I removed the headlights completely from my truck and did the refinishing inside. I don’t know how easy that is on other vehicles.
I did that kit on my 07’ Ford Focus. Worked great, took an hour or two (including a few beers), and has been holding up over 2 years with no fading yet!
I don’t think toothpaste has a low enough grit to make a dent in plastic this worn by itself. You need a lower grit abrasive to start with and taper to a higher grit
Does toothpaste work to de-cloud headlight housing or is that one of those urban myths?
Yes. Any fine abrasive will. But it typically doesn’t last long unless you keep a coat of wax on them.
I tried it, it helped a little, tried rubbing compound too, it worked a little better. I would go this route for sure
The kit was $17 on Amazon. You can order direct from Cerakote too, but you have to pay like $6.99 shipping. Kit was worth it. It was not difficult at all! Might have been a little easier for me because I removed the headlights completely from my truck and did the refinishing inside. I don’t know how easy that is on other vehicles.
I did that kit on my 07’ Ford Focus. Worked great, took an hour or two (including a few beers), and has been holding up over 2 years with no fading yet!
Do you live in the USA? Don’t you have these large (and usually cheap) car part/DIY/outdoor stores? Cause that’s where I bought that kit.
I don’t think toothpaste has a low enough grit to make a dent in plastic this worn by itself. You need a lower grit abrasive to start with and taper to a higher grit