How would you neatly and consistently round over the ends of dozens of 1/2" dowels?

@AMillionMonkeys · 2 years ago

How would you neatly and consistently round over the ends of dozens of 1/2" dowels?

@AMillionMonkeys · 2 years ago

I was thinking horizontally. I’d hesitate to do it vertically since gravity would be pulling the stock into the bit. If anything went wrong it’s not exactly fail-safe.

Golfnbrew · 2 years ago

I think the roundover bit is your best bet. But you don’t have to go vertical. Horizontal, perpendicular to the fence of a router table. You will need to build a jig somehow.