A few real life examples, all of which I’m in the middle of:

  • Fixing this closing mechanism for this box in the kitchen. A bit of trial and error to 3d print a replacement for this part that broke off.
  • Learning Rust. I got fluent in Perl in the previous century, and never quite got to that level with anything else. I figured it’s time to pick up something more modern.
  • Sorting out my homelab/selfhost setup. The hardware is in place, but the software side isn’t quite there yet.
  • The greywater vent goes up to the attic. I have started planning adding a vent and some more piping to place the endpoint outside, but it’s probably not gonna be done until spring as it’s cold as fuck these days.
  • Autopilot module for an RC aircraft, complete with altitude and attitude adjustments. Next up on the too list is navigating through waypoints. If budget allows I will build a plane around it next year.
  • Homebrewing a weather station door bell camera combination. Early planning stage.
  • DonkeyStar
    link
    fedilink
    arrow-up
    2
    ·
    48 minutes ago

    I’ve been working on fixing sagging floor joists, but it’ll be out of my hands soon. Found some broken ones that fungus had gotten to, but I’m thankfully covered by insurance for that.

    I need to build a small staircase, sand and paint a deck, and take advantage of the cold to remove vines and brush I let take over during summer.

    Inside, I’ve got a tv with a fault somewhere between the backlight and the power board, but neither part is available to buy from my favored shops, so I’m going to try replacing board bits. Related to the joists, I bought an RC car with a camera to run in the crawlspace to do an inspection. It said it had lights. It does, but they’re decorative. So I’m going to rewire it and attach white LEDs to the camera so that I can see in the dark like I originally intended. Not that I need the car anymore, but why not?