I am playing with three +/- 3.2 Vf blue LEDs in series on a breadboard, using a 12V battery. I have many different kinds of resistors to choose from.

As explained here at 08:35 and here, to calculate the resistance necessary to protect the LED(s), I subtract the forward voltage from the supplied voltage to first find the voltage drop of the imaginary resistor. Here: 12 - (3.2 x 3) = 2.4 . I then use Ohm’s, dividing the resistor’s voltage drop with the current necessary to drive the LED(s) (as per the manufacturer’s specs? But let’s suppose 20 mA). Here: 2.4 / 0.02 = 120.

jmdNvD9klqQLIQa.png

  1. I don’t understand what The Engineering Mindset means by “our resistor needs to remove the remaining voltage”. That sounds like adding up to what the power source supplies. Doesn’t that leave us with 0V to work with, meaning, no work should happen…? Or is the “remaining EXCESS voltage” we’re talking about here?
  2. In the image, I’m using a honking 1.2kOhm resistor, so how on earth are the LEDs emitting light? Does the above calculation mean that I could keep decreasing the resistance all the way to 120 Ohms-ish and still without them burning out?

Obviously a layperson here, so explain it as if I was five. 🥰

  • bizarroland
    link
    fedilink
    English
    arrow-up
    3
    ·
    edit-2
    17 hours ago

    From what I understand, the resistor is limiting the amount of current draw that can be drawn into the LEDs because otherwise LEDs will draw whatever voltage is applied to them and burn out if it’s over their limit.

    The resistor itself should not absorb very much energy, and what energy it does absorb would be turned into heat.