@ExplodeyWolf to [email protected] • 1 year ago20gb ram, 10gb zram, 10gb swap, default values. What should I change?message-square17arrow-up129arrow-down15file-text
arrow-up124arrow-down1message-square20gb ram, 10gb zram, 10gb swap, default values. What should I change?@ExplodeyWolf to [email protected] • 1 year agomessage-square17file-text
I assume I should get rid of most of the swap. I also read somewhere to increase… swappiness of zram?
minus-square@wheelslink1•edit-21 year agoThere’s some instructions here but basically: sudo apt install zram-config append to end of /etc/sysctl.conf: vm.swappiness = 180 # disable swap readahead (since using zram swap) vm.page-cluster = 0 Can check these have been applied with cat /proc/sys/vm/page-cluster or .../swappiness
minus-square@ExplodeyWolfOPlink1•1 year agoWould these settings be the same if I used the same amount of swap?
minus-square@[email protected]linkfedilink1•1 year agoHave a look at this for info on swappiness. As for your swap, if it’s not causing you problems, it can’t hurt to have it.
Should I lower swap? How do I change the swappiness?
There’s some instructions here but basically:
sudo apt install zram-configappend to end of
/etc/sysctl.conf:vm.swappiness = 180 # disable swap readahead (since using zram swap) vm.page-cluster = 0Would these settings be the same if I used the same amount of swap?
Have a look at this for info on swappiness. As for your swap, if it’s not causing you problems, it can’t hurt to have it.