cross-posted from: https://lemmy.dbzer0.com/post/6251091

I have this:

https://www.aquaplan.com/product/easy-band/

I need to attach it vertically to some thick hard rubber roofing. There is a small section of roof which should probably normally have a parapit but instead the roofing rubber is not backed by anything. Then below it is a wood panel. So when it rains sideways the water runs down the roofing rubber and behind the wood panel.

I just need a piece of shingle to divert water to the exterior side of the panel. Roofing glues are made to never cure. Probably rightfully so, but that probably wouldn’t work to attach a shingle vertically as gravity would over power that tar-like never fully dry stuff. I tried construction adhesive & it didn’t hold.

  • emenaman
    link
    31 year ago

    Without seeing it, the best solution I can think of is to try cleaning it up real good with something like Simple Green(works amazing on rubber). After it’s nice and dry, use some Eternabond RoofSeal tape making sure to have at least two inches overlap. That stuff will stick well to clean rubber and hold good for a few more years. Nothing will ever be a permanent solution until you can replace the whole piece of rubber roofing unfortunately .

    • @[email protected]OP
      link
      fedilink
      01 year ago

      I don’t have anything specialized like simple green, but wouldn’t acetone or denatured alcohol make a decent primer? I think priming the smooth rubber surface should be the easy part but it’s the bitumen band that’s tricky. It has a sandy texture and sand crumbles off when I rub it. Perhaps I should steel brush it where it needs adhesive.