I’ll start out saying, i’m not very good with this stuff… I have an Ender 5+.
I had it setup with octoprint and klipper from a guide I found a couple years ago, and it worked OK for me to get klipper installed, working on octoprint, and pressure advance tuned ok ish.

Recently my SD Card became corrupt, and like an idiot I didn’t have anything backed up.

So I’m trying to setup the system again from less than scratch and it’s kicking my ass.

I’ve decided i’d like to try Mainsail, as it’s interface looks interesting (no other reason) But I can’t for the life of me get it working.

EVERY guide I try and follow seems to fail on the connect between klipper and the printer.

I can flash the klipper firmware successfully, and have updated the port ID in the printer.cfg file, but it always comes back to klipper not being able to see/access the port.

Any help would be appreciated here.

  • @stoppillowrapeEnglish
    1•1 year ago

    I forgot you will also need tty access, so you’ll also need to do:

    sudo usermod -a -G tty $USER

    After that you will need to relogin in order for the changes to take effect. I’d say just to reboot so you know everything is reloaded with:

    sudo reboot now

    These are all of course assumptions based on your mentioning permissions, and without any logs to verify. If you decide to go with the nuclear option and redo the OS and setup I’d recommend looking at using https://github.com/th33xitus/kiauh. It will allow you to setup Mainsail, but also you can try other front end options as well. Just something to consider if you decide not to continue troubleshooting and opt to start over.