ilovecheese to [email protected]English • 2 years ago3D Printed The Key From a Photoimagemessage-square7arrow-up121arrow-down10
arrow-up121arrow-down1image3D Printed The Key From a Photoilovecheese to [email protected]English • 2 years agomessage-square7
minus-squareGhostalmedialinkEnglish10•2 years agoThat’s a lot of effort for master lock. You could’ve just farted in the key way to open it.
minus-squareilovecheeseOPlinkEnglish4•2 years agoThey’re so bad that this isn’t even the key to that master lock! lol To be honest that’s why I chose it. I’m not sure consumer grade FDM stands a chance at a lock with decent tolerances.
minus-squareilovecheeseOPlinkEnglish1•edit-22 years ago@[email protected] I’m unable to reply to your comment, have same issue in other posts here too, so had to reply here. Very nice! I’m impressed with the PIP bearing! Resin prints are the way to go! One day I’ll get one! Off to see if I can find how they created a model from a photo of angled faces now!
That’s a lot of effort for master lock. You could’ve just farted in the key way to open it.
They’re so bad that this isn’t even the key to that master lock! lol
To be honest that’s why I chose it. I’m not sure consumer grade FDM stands a chance at a lock with decent tolerances.
deleted by creator
@[email protected] I’m unable to reply to your comment, have same issue in other posts here too, so had to reply here.