Klipper started throwing an error and shutting down while trying to heat the extruder. The extruder was cold, which basically meant a heater wire break. Thankfully it was very easy to find. So much for buying a nicer harness. Grumbles aside, I wonder if this wire got pinched when I assembled the chains, which lead to an early failure.
I didn’t have any spare PTFE wire on hand, so I spliced in a length of 16 gauge silicone wire and made sure to land the solder and heat shrink sections well away from any possible motion. I have replacement wire on order, but am tempted to run as is until it fails again…
I have a rapido HF. The thing heats up really fast, so it must be pulling some juice. What wire gauge did you wind up going with? It looks like the heater is rated for 115 watts, which is roughly 5 amps.
I think I have 16 AWG on it now, which is definitely overkill. It’s been a wild journey of mods so I’m not even sure what I last installed. I got rid of drag chains and the Huvud CAN board was finicky about voltage drops so I went a bit overboard. I just remember the 24 AWG copper was insufficient for CAN + Rapido HF despite the shorter run and being an IGUS branded cable.
Here is the 16 AWG wire I used: https://www.amazon.com/dp/B089CW1YGM