Good day! I am running a Klipperized Sovol SV06+ and have been getting some really great prints. I am however having an issue where lately I am having to adjust the Z offset with each new print. I did a first layer calibration and got a perfect result but after a couple prints I saw I needed to lower it to get a good first layer. Again I printed a few and then again I needed to lower it. This has happened a few times.
Yesterday I was printing a pretty large print and midway through the extruder shifted (the print remained secure to the bed) and continued printing. After I canceled the print I had to lower the Z offset much further than I thought was possible. I am concerned that the bed keeps “lowering”.
I have a very good bed mesh loaded (used the silicone bed leveling mid I have seen discussed). I am just unsure why this is needing to be adjusted and why the last print went wonky (related?)
Thanks much!
The printer bed is non adjustable. It relies solely on auto bed leveling. I did a silicone base mod to actually adjust the bed and level it manually in addition to the abl. That is why I had such a great mesh loaded.