Why would this happen? Should I try replacing the wire nut and turning it back on or is there something deeper going on? Thanks for any tips!

  • @P00Pchute
    link
    17
    edit-2
    11 months ago

    This is more of an electrical problem rather than a plumbing issue. But rust inside the junction box is a sign of water getting into it. You need to find the source of the water that’s getting in and stop that too. It looks like there is only a bad connection inside the wire nut. Most likely due to being wet. You can try changing the wire nuts if you feel comfortable with electricity.

    1. Switch the breaker to “off” and lock it out & tag it so nobody turns it on accidently.

    2. Verify power is off to both wires with a meter or voltage indicator.

    3. Cut back the wires until you have a good section of wire to strip and install new wire nuts. (Remove one wire nut at a time so you don’t mix wires.)

    If you are not comfortable with electricity please do not attempt this repair and contact someone who is.

    • @mystik
      link
      211 months ago

      The rust and/or bad connection will create resistance at the connection, which can cause it to heat up as well. If that’s what happened, it could have melted the wire nut slowly till the wire was exposed, and shorted against a metal part. It looks like there is a diagram of the wiring too to the left near that connection too, which may help if you need to disconnect/reconnect it.