The cockpit voice recorder data on the Alaska Airlines Boeing 737 MAX 9 jet which lost a panel mid-flight on Friday was overwritten, U.S. authorities said, renewing attention on an industry call for longer in-flight recordings.
National Transportation Safety Board (NTSB) chair Jennifer Homendy said on Sunday no data was available on the cockpit voice recorder because it was not retrieved within two hours - when recording restarts, erasing previous data.
The U.S. requires cockpit voice recorders to log two hours of data versus 25 hours in Europe for planes made after 2021.
The International Civil Aviation Organization (ICAO) has since 2016 called for 25-hour recording on planes manufactured from 2021.
“There was a lot going on, on the flight deck and on the plane. It’s a very chaotic event. The circuit breaker for the CVR (cockpit voice recorder) was not pulled. The maintenance team went out to get it, but it was right at about the two-hour mark,” Homendy said.
The NTSB has been vocal in calling for the U.S. to extend its rule to 25 hours. The U.S. Federal Aviation Administration (FAA) a month ago said it was proposing to extend to 25 hours – but only for new aircraft.
This isn’t entirely an excuse, but a CVR has some pretty serious durability requirements. They’re required to withstand physical forces, sustained exposure to direct flame, lengthy submersion in sea water…it’s not a trivial device.
How much could a banana cost, Michael? 10 bucks?
Here’s some money, go see a Star War
On top of all that, you have to factor in the development and testing costs for the CVR or FDR too. These are usually off the shelf, previously developed components. A seemingly trivial change like bigger storage suddenly costs several hundred thousand dollars to retest and time to recertify by dozens with agencies around the world. If the regulations have not changed, then there is no reason for to go through that whole R&D process again when the same bought and paid for system works.
…which you’d think has all already been done, since Europe pretty much uses the same airplanes as the US, so compatible equipment ought to exist.
You have to recertify the component on each aircraft you install it on. If the manufacturer doesn’t have a reason to update a component they won’t recertify it.