@JoshuaSlowpoke777 to No Stupid [email protected] • 9 months agoIs PLA a good material for 3D printing a tool intended to remove pack ice from a driveway?message-square8arrow-up19arrow-down12
arrow-up17arrow-down1message-squareIs PLA a good material for 3D printing a tool intended to remove pack ice from a driveway?@JoshuaSlowpoke777 to No Stupid [email protected] • 9 months agomessage-square8
minus-square@JoshuaSlowpoke777OPlink1•9 months agoI was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
I was thinking something like a chisel, but yeah, these comments suggest even that would break before the ice.
Try salt?