Fpm101 build by Sadek Baroudi (fingerpunch kb), case designed and 3D printed by me. It uses keyboardio key caps and has matias clicky alps clones. It has a scroll ring around the trackball also!
Can’t wait to use lemmy!
Fpm101 build by Sadek Baroudi (fingerpunch kb), case designed and 3D printed by me. It uses keyboardio key caps and has matias clicky alps clones. It has a scroll ring around the trackball also!
Can’t wait to use lemmy!
If you don’t mind sharing, how much did this cost to build?
Well, that’s a bit hard to nail down, the board is not for sale yet so, I’m not sure the price is nailed down. The plate is laser cut acrylic I got on special from elecrow for $4. The Keboardio keycaps were on sale for $5 a set for the alps version. I went cheap and got Matias clicky switches (alps clones), $40 for 200. I also used half a roll of filament for the case, about $20, and screws I had on hand. All in, disregarding prototype cases, around $280 to $300.