I started mucking about with ESPHome yesterday and setup a WROOM with an AHT22 temp/humidity sensor. Running the wizard and adding the configs is easy-peasy. I started to have issues as soon as I wanted to flash.

• If the AHT22 is plugged in, I cannot flash the device over USB.
• I can check the serial logs once the device is flashed and then plug in the AHT22 once the device is booted and get readings, but
• Once I unplug the ESP32 from the serial port and plug it into a power supply, I got nothing. No network activity at all.
• Unplug the AHT22, plug into the power source, wait a few seconds, plug in the AHT22 has seemed to work correctly this morning and HA is pulling data but I tried that last night a few times and it didn’t work – so unsure why it’s working this morning other than strange timing when I’m plugging the thing back in.

I am using the basic esp32dev firmware, which I am assuming works because it DOES work, eventually, but I’m not confident I’m using the right base but I cannot figure out which one to use.