And, any idea how to use them? 3 pins is perplexing.

  • @j4k3
    link
    English
    12
    edit-2
    8 months ago

    Wrong stuff removed

    • @EdibleFriend
      link
      English
      188 months ago

      AAAAH I LOVE YOU FLASHLIGHT LOVING BASTARDS

      Seriously every time this group crosses my feed it makes me so goddamn happy. You guys and you’re incredible niche little love that you know so much about I fucking love it

    • @[email protected]
      link
      fedilink
      English
      98 months ago

      Nope.

      UPDI used on Atmel micros on Anduril capable flashlights uses a single line for debug and flashing. Much earlier than that, Motorola/Freescale/NXP Coldfire, S12, and some other MCUs used BDM which was also a single wire protocol.

      If you want to flash a newer Anduril to this light, look here for hardware and procedures to use those pads.

      • @solrizeOP
        link
        English
        38 months ago

        Wow are you saying this light has updi and a t1616? Nice! I knew that the sp10 pro has that but I had thought the LT1S was older. I just checked my sp10 pro though, and sure enough, it has similar contacts. So this is welcome news. Thanks!

      • @Manfred
        link
        English
        1
        edit-2
        8 months ago

        The programming hardware won’t help because the firmware is closed source.

        • @[email protected]
          link
          fedilink
          English
          18 months ago

          You don’t need the original source to program a flashlight. If it’s ATTiny based then Anduril has your back.

          • @Manfred
            link
            English
            28 months ago

            I agree. If you are able to define the HW specific part of Anduril for this new model you can create a hex file and flash it.

    • @[email protected]
      link
      fedilink
      English
      38 months ago

      Aren’t most microcontrollers programmed over UART? AVR has their own one wire programming interface, but neither use clock signals.

      • @j4k3
        link
        English
        18 months ago

        One wire is more for just a few sensors. I think the STmicro stuff has a 1 wire option. At least one of my programmers has a label for it, but with all my hobby stuff, I’ve never used 1 wire for programming. I have only used it for a temperature sensor as far as I can recall. Everything is either JTAG or UART in my limited experience.

        • @[email protected]
          link
          fedilink
          English
          48 months ago

          So there’s the OneWire protocol that’s for sensors, different microcontrollers will implement a programming protocol using a single wire, which is what I meant.

          Jtag has a clock signal, but is generally 5 lines.

          My point being that looking for similar trace lengths because one is a clock signal isn’t sound advice. All the common protocols either don’t use a clock signal, or are more than two lines.

    • @solrizeOP
      link
      English
      38 months ago

      I won’t know for sure without doing a reflash, but I think al177 has the right answer: those pads are for the UPDI system on newer AVR’s, so this is great news once I can get a UPDI dongle. My D4v2 uses an older chip and 6 contact pads. Thanks for the response though!