@Pmdude to 3D [email protected] • 2 years agoHelp with supportsi.imgur.comimagemessage-square6arrow-up19arrow-down11file-text
arrow-up18arrow-down1imageHelp with supportsi.imgur.com@Pmdude to 3D [email protected] • 2 years agomessage-square6file-text
minus-square@wildergheightlink3•2 years agoI’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
minus-square@[email protected]linkfedilink6•2 years agoAlso in this case it might make sense to split the model, then glue it together.
I’m not sure what orientation you’re printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you’re always going to have a rougher surface than printing without them
Also in this case it might make sense to split the model, then glue it together.