In other cad programs i use two points of a sketch to extrude a feature. In freecad it does not seem to be possible. What are your recommended workarounds for that?

I would like to extrude the base not just from the face of the sketch, but from point 1 to point 2 on the side view sketch. This workflow proved very robust in other cad tools, but I cant get it work in freecad.

Thanks a lot in advance!

  • @thantik
    link
    English
    18 months ago

    Welcome to Freecad; where you’ll be making up pointless workarounds like this constantly because the workflow is nonexistant.

      • @thantik
        link
        English
        18 months ago

        Yeah, I want it to be better too. I want FreeCAD to be the Blender of parametric modeling; but after 20 years, it’s just not there yet.

        • @[email protected]OP
          link
          fedilink
          18 months ago

          I am actually very optimistic about ondsel and I hope there will be more money and coordinated work put in this software. I suspect freecad to be a lot more usable in 2 years if ondsel continues to grow and improve :)

    • @BOFH666
      link
      18 months ago

      Thanks for the tip, never heard of Ondsel, but will check it out tomorrow!

      • @wjrii
        link
        18 months ago

        Ondsel doesn’t fully implement the RT toponaming fix, but their employees (generally hired from the existing volunteer devs) are among those pushing to get it into Mainline FreeCAD, as Ondsel is barely a fork for now and very heavily reliant on the 0.22 beta.

        Also, for your specific question, I think the main FreeCAD forum is still your best bet for a practical answer.