I’ve installed a new battery on my laptop, but to my surprise, the percentage of charge in the battery is at 0. Here’s the upower
diagnostics:
$ upower -i /org/freedesktop/UPower/devices/battery_BAT0
native-path: BAT0
serial: 0
power supply: yes
updated: Thursday 11 July 2024 09:54:55 PM (16 seconds ago)
has history: yes
has statistics: yes
battery
present: yes
rechargeable: yes
state: pending-charge
warning-level: none
energy: 0 Wh
energy-empty: 0 Wh
energy-full: 0 Wh
energy-full-design: 0 Wh
energy-rate: 0 W
charge-cycles: 100
percentage: 0%
technology: lithium-ion
icon-name: 'battery-caution-charging-symbolic'
The “energy-full-design” capacity of the battery should be 70Wh, but here it is, at 0Wh. None of the statistics above (except date and time) have updated, and it’s been two days already. How do I calibrate this battery?
This doesn’t sound like a calibration issue, but a driver issue sadly. It’s possible your new battery uses a different gas gauge IC that isn’t supported (yet).
Have you tried turning it off and on again?
The laptop? Yes, I’ve done this already. I’ve also removed the battery and the CMOS, held the power button to discharge the laptop, booted it without the battery, and then installed it again.
It reads that data direct from the batteries BMS hardware, I don’t think battery calibration has been a thing since NiCD/NiMH days in the 90s and stuff.
deleted by creator
I’m not even sure what kind of behavior is this from a battery - it blinks even when I put in the charger, however it has stopped blinking since the time I’ve put in the charger for almost more than a day. But the value is still at zero - and ironically, it does not shut down immediately - maybe after two-five hours? Is the PCB a goner?
Hmm possibly a connector from the battery to motherboard that didn’t fully seat?
Or if it’s an aftermarket battery maybe it doesn’t have the right hardware in it to talk to the computer or something.
You can’t.
The laptop talks to the battery and the software you’re using tries to talk to the laptop to see what the battery says. What’s your laptop make and model, battery make and model and did you check the bios for battery configuration?
It’s a Lenovo S540-15IWL, with the MX250 dGPU. I’ve tried checking the BIOS, and there seems to be no setting for the battery in the BIOS.
Okay, clear the old upower data stored in your computers /var/lib/upower/ directory with rm /var/lib/upower/* then restart the upower service or just restart your computer.
Have you tried running the laptop down until it shuts off then charging it?