Hi all,

I’ve had my cyan D4K Hanklight for only a few months (ordered in April) and I can’t seem to get my main emitters to turn back on? I had the light on while cable managing my PC and all of a sudden it turned off. I didn’t touch the switch, it just cut off.I checked the cell first which runs fine in my K1 and was at 60% capacity. I’ve tried these 2 factory reset methods:

  1. 13H (I held for 5 seconds), and
  2. disconnect tail cap, hold switch, reconnect tail cap, release after 4 seconds.

Neither appear to do anything. The auxillary LEDs are still running in low mode, but I can’t seem to change them with the usual 7C for mode and 7H for color.

Is there any possibility my dedomed 519A emitters are still alive and kicking? Or should I just order a “domed” normal version?

Thanks for reading!

  • @solrize
    link
    English
    31 year ago

    I’d email Hank. I doubt all the emitters would fail in the same instant, so this sounds like the driver board or some of its wiring has failed.

  • @ZakM
    link
    English
    21 year ago

    This definitely sounds like a bad driver, not a failure of the emitters. I don’t think there’s a warranty as such on these, but I bet Hank will send you a new driver if you can solder.

    • @solrize
      link
      English
      21 year ago

      3 month no charge repair, then repair at cost up to 12 months, per this:

      https://intl-outdoor.com/cs-Guarantee-page

      I have not personally swapped a driver board in these lights, but multiple people have told me it’s a big pain. It’s one reason I only buy lights with flashing pads, rather than lights that you have to take apart to reflash, if they run Anduril.

      • @ZakM
        link
        English
        21 year ago

        I pulled a driver in a first-generation D4. It wasn’t too bad. The new ones would be more work because they have aux LEDs.