@Camzing to Ask LemmyEnglish • 2 months agoIs it feasible to turn manufacturing most simple products into open source? Is this the future?message-square41arrow-up182arrow-down13
arrow-up179arrow-down1message-squareIs it feasible to turn manufacturing most simple products into open source? Is this the future?@Camzing to Ask LemmyEnglish • 2 months agomessage-square41
minus-square@[email protected]linkfedilink8•edit-22 months agoI think there’s a guy that’s trying to 3d print an entire 3d printer. Maybe he already did it, I haven’t been keeping up.
minus-square@spittingimagelink5•2 months agoDo you mean the RepRap? Seems like there’s not much going on at the wiki.
minus-square@[email protected]linkfedilink3•2 months agoIt was the original home 3d printer, but it kinda got overtaken by cheap mass produced printers. Prusa was originally a member.
minus-square@[email protected]linkfedilink1•2 months agoDidn’t he close source a bunch of the parts to his newest printer?
minus-square@HootinNHollerinlink1•edit-22 months agoI donno but If he did it’s because bambu etc are ripping him off
I think there’s a guy that’s trying to 3d print an entire 3d printer. Maybe he already did it, I haven’t been keeping up.
Do you mean the RepRap? Seems like there’s not much going on at the wiki.
It was the original home 3d printer, but it kinda got overtaken by cheap mass produced printers. Prusa was originally a member.
But tbf, Prusa carries on the spirit
Didn’t he close source a bunch of the parts to his newest printer?
I donno but If he did it’s because bambu etc are ripping him off