I started resin printing and I am wondering if you guys use a full on resperator (if so is their a specific classification you’d recommend?) Or do you just use a cloth / surgical mask?

So far I have been using the mask that came with my printer (Elegoo mars 3 pro) but and not sure if that is sufficient.

  • @cat4lyst
    link
    English
    11
    edit-2
    1 year ago

    If you’re smelling a strong odor then a respirator would be advised. You need one with an organic vapor cartridge. Surgical mask is doing nothing for you in this situation. Probably easier just to get some good ventilation going though. Or minimize you time around the printer.

    • @AverageGoobOP
      link
      English
      21 year ago

      I could open my garage door however I am worried about letting in sunlight and ruining and/or damaging the prints.

      I will take a look for the respirator and cartridges you mentioned!

      • @[email protected]
        link
        fedilink
        English
        51 year ago

        In addition to other suggestions, you could also set up a barrier (cardboard box) that would shade your printer from direct sunlight when the door is open.

        You also don’t need the door open fully. Just open a few inches and turn on a box fan.

        • @[email protected]
          link
          fedilink
          English
          21 year ago

          That’s exactly what I was doing when I used mine. Used the cardboard box the printer came in, and cracked the garage door with a fan pointed at the printer towards the door

      • @cat4lyst
        link
        English
        41 year ago

        You could also just let the print finish. Then open the door before you go out there to gather it. giving it a few minutes to vent. I have minimal experience with resin printing so I don’t know how the sunlight would affect it. Putting the printer behind something to block the light seems reasonable as well.

        Good luck. You can find these respirators on Amazon. 3m is a common brand.