Hi

A couple of days ago the hotend wouldn’t heat up and i got a couple of errorcodes/warnings in the display. The bed heats up just fine, so i ordered a new hotend parts (heater, thermistor and a new aluminum block). Changed all of this, but still the same error. I can se that the thermistor works because it changes values in the display when touching the thermistor-end. Any good ideas why the heater doesn’t heat?

  • @WordBox
    link
    English
    24 months ago

    $80 makes it reasonable. At normal MSRP… Ender.

    Good luck and make upgrades slowly and as needed.

    • @[email protected]OP
      link
      fedilink
      English
      14 months ago

      Haha, slowly it goes… Changing the SKR v1.4 to a SKR MINI V3 isn’t straight forward on the Biqu B1.