Created a new replacement dust adapter for my circular saw that replaces the original one. The original didn’t fit my Nilfisk Multi II 30 shop vac. Now I don’t need to fiddle with the adapter I first made.
Sharing if someone has the same combination: https://makerworld.com/en/models/996710
Printed the same as you, a standing tube. I used PETG for the best layer adhesion. The walls are 3 mm thick solid. It has held up fine so far, but i haven’t had the opportunity to put heavy use on it yet.
I actually thought about it before printing it and my backup plan is to print it at 45 degrees angle with more supports if it doesn’t hold up.
Let us know how you get on!
I tried the 45 degrees method, but my print bed wasn’t quite large enough to make it fit. It ended up too short and the hose kept falling out.
Will do! Planning to put some OSB boards up this weekend. Should be a fair test by going through a stack of ten boards.