Finally got it out of the box, setup, explore the new features, amazed at those, and the extreme exhaust fan noise.

So what do I do with this monster that I couldn’t do with my ender 3? yup bag clips.

  • SzethFriendOfNimiEnglish
    2·
    1 年前

    Is it running Klipper or something else?

    In Klipper I have my controller board fan set to speed up only when there’s any active heaters or stepper drivers?

    E.g. fires up only when moving/heating or printing but not when idle. Even then it’s set to a reasonable 80% threshold.

    • TerraRoot@sh.itjust.worksOPEnglish
      3·
      1 年前

      It has klipper but not mainline klipper, looking at some firmware updates that might automagically fix this. gotta confirm what I currently have.

      • SzethFriendOfNimiEnglish
        1·
        1 年前

        Here’s what that looks like for me. Basically a controller_fan configured to kick off with the steppers.

        #Case fan for cooling when heating bed [controller_fan controller_fan] pin: YOUR_FAN_PIN_HERE heater: heater_bed stepper: stepper_x,stepper_y,stepper_z heater_temp: 40.0 fan_speed: 0.8 shutdown_speed: 1.0 kick_start_time: 0.5

        • TerraRoot@sh.itjust.worksOPEnglish
          1·
          1 年前

          Thanks, so in sv08’s case, I’ll have to open the bottom and plug the fan into another header before updating printer.cfg just like your example.

          The firmware update is a .deb file, I know this, it’s a unix debian system!