I’ve printed probably 5 kilos worth of prints with a lot of success, but exclusively PLA. I’d like to branch out to a new material. Should I start with ABS or TPU?
I’ve printed probably 5 kilos worth of prints with a lot of success, but exclusively PLA. I’d like to branch out to a new material. Should I start with ABS or TPU?
I designed and printed a fender for my kid’s bike. It would be totally usable as a fender but he’s a savage so he broke the first one within 30 seconds of me installing it. Then I changed the design to add more support and that one lasted a full hour before he broke it off. So I’d like to print the same design again in a new material. I think either of these two would work, as they would put up with more abuse in different ways. one would be much harder and the other more forgiving.
I don’t love the idea of the toxic fumes. I don’t want to get an enclosure and the printer is in my home office off of my living room. I could crack a window and let it run overnight but that sounds inconvenient.
TPU will be nearly impossible for your kiddo to destroy. ASA/ABS are rugged, but if your print has thin surfaces it’s less strong in my experience than PETG.
I didn’t find TPU hard to print personally, just go slow and turn retraction way down or completely off. It will string pretty good, but most slicers have a setting to avoid crossing perimeters that will keep it in check. The only thing I would be wary of is ending up with a floppy print, so make sure the part has some structure.
Don’t forget about material wear due to UV radiation. ASA is good for outdoors projects, rugged, not as toxic and UV degradation is minimal.