Is this beyond the pale? Recently got a Neptune 3 pro and have been having issues. Anyone have some tips? Is this resolvable? Can a bed for these be replaced?

I uncommented the Gcode line to use this matrix now which I didn’t before. But still having a lot on inconsistencies.

  • solarbird
    link
    fedilink
    21 year ago

    It has pegs but I was able to see that there are rather typical screw heads in the heating plate to hold it down onto the bed’s support frame, and if you look you can see the bolt ends coming down out of the underside of the supporting arms.

    So I think what’s here is pretty simple: regular bolts with fixed length spacer tubes around them.

    And that means that OP should be able to sort this out with, say, the right collection of 0.5mm-thick washers. One on the front left screw, three on the right rear screw, uh, six on the back left screw should get close enough for the mesh to handle the remaining difference.

    • @[email protected]OP
      link
      fedilink
      English
      11 year ago

      Are you referring to the screws underneath the build plate? Or do you mean the bolts to the frame? I’ve never had to go this far to level a bed so want to make sure I’m doing this right

      • solarbird
        link
        fedilink
        11 year ago

        Yeah, under the build plate there are four bolts pointing down. Those bolts.