Context: I am on a personal agenda to backup all my games myself. In this search I landed on the Open Source Cartridge Reader (OSCR) it was expensive so I held off until a few months ago when I could finally afford it.
When I got it, I also bought every adapter I needed including the Virtual Boy one, which comes as a Kit. I didn’t think it looked bad, which is why I ordered it. But I held off on making since I started getting cold feet.
Today however I got the courage to try and… it was awful. 60 teeny tiny pins needed to be aligned and individually soldered. It was setup so a skilled micro solder could doing the job in an hour or so… it took me 4 hours and scouring the floor finding pins which fell. Let alone unclogging holes which were accidentally soldered.
However after testing my patience and redoing the last step 3-5 times. It works!!!
Now I can play Jack Bros without a VB, and Viper on 3DS is amazing.
Shoutout to Save The Hero Builders. I got everything from them and they were extremely helpful with a noob like me.
get yourself one of these if you want to continue to DIY. it will save you from having to redo any work and remove the stress of soldering in the first place. I used to basically use a hot tenpenny nail as an iron, and saved myself so much stress and selfdoubt by using a similar iron.
https://www.amazon.com/dp/B0D86FF2M1
also, some good resin, and desoldering braid.
also, get yourself one of those copper scouring pads at the grocery store as a tip cleaner. squirt some of that no-clean resin on it and you have a pretty good soldering station. with some proper practice you can make some professional looking joints within a few hours.