75 degrees = 68 degrees. No wonder I couldn’t get things to adhere well sometimes.

As a side note, the temp varies wildly along the plate base. An enclosure would definitely help here.

Has anyone else tested the actual temps versus the set/displayed temps and noticed a difference?

  • ffhein
    link
    English
    51 year ago

    A lot of printers also heat the bed unevenly, so the temperature could be significantly higher in the centre of the build plate. This video shows it fairly well. You could try adding a few minutes delay to your start gcode after the printer thinks it’s reached the correct bed temp, to let it even out a little.