@rustyriffs to 3DPrintingEnglish • edit-22 years agostringing suggestions?message-square33arrow-up123arrow-down10file-text
arrow-up123arrow-down1message-squarestringing suggestions?@rustyriffs to 3DPrintingEnglish • edit-22 years agomessage-square33file-text
minus-square@[email protected]linkfedilinkEnglish1•2 years agoOk, so you don’t torch the print directly? Just heating up a screwdriver any lighter should work right?
minus-square@GorrothlinkEnglish1•2 years agoNo, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
Ok, so you don’t torch the print directly? Just heating up a screwdriver any lighter should work right?
No, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
Ok. I’m going to give this a try thx.