The flex plate makes it 1000x easier to remove the print, but I had an issue with it coming off the magnet a tiny bit when pulling off the FEP and sliding laterally a bit causing layer shift. It needs some little 90⁰ tabs on the sides to keep it aligned with the plate.
The flex plate makes it 1000x easier to remove the print, but I had an issue with it coming off the magnet a tiny bit when pulling off the FEP and sliding laterally a bit causing layer shift. It needs some little 90⁰ tabs on the sides to keep it aligned with the plate.
I haven’t experienced that. How big is your bed.
I had the same issue. Scrapped off the magnet and went back to printing like a caveman on the bare plate.