Made sure the stock firmware printed the example gcode that came on the SD card and then immediately embarked on my journey to get klipper running on this guy.

I didn’t finish until the wee hours this morning so I’ve yet to really give it a go but all the essentials are operational.

Here’s the GitHub link to the config I created: https://github.com/0xD34D/ender3-v3-se-klipper-config

  • troydowlingEnglish
    2·
    2 years ago

    Is that about 20 degrees of swing on the hotend? Might need to recalibrate that loop!

      • troydowlingEnglish
        2·
        2 years ago

        Oh, of course. That explains the coefficient output in the terminal. Thanks.