Hi all! I was curious to see if anyone had any recommendations for an enclosure for the Ender V3 Neo. I found a few on Amazon, but they look like grow tents and wasn’t sure if that would work well. For a bit of context, it seems like an enclosure is a must have for ABS printing which is ultimately what I’m after.

Thanks everyone!

  • @[email protected]English
    2•11 months ago

    They work decently. I’ve never had an issue printing ABS with my comgrow one (I can actually print it easier than petg).

    Although I am in the process of converting an old oven into a heated build chamber.

    • @Koopa_KhanOPEnglish
      1•11 months ago

      Thank you! That’s what I’ll go with

      • @[email protected]English
        1•11 months ago

        NP. You don’t need a whole lot to get the chamber temps to be ABS friendly. I do recommend keeping it open if printing PLA, though.

        • @Koopa_KhanOPEnglish
          1•11 months ago

          Does it just get to hot for pla to cool if its closed up?

          • @[email protected]English
            2•11 months ago

            Yeah, it will affect the print quality because the layers don’t cool off enough in between layers.

      • @[email protected]English
        1•11 months ago

        I don’t. I dont print enough ABS to worry about fumes.

        Although I do have a fan in my office door to suck air out (I also have a 55g aquarium and gaming rig, so it gets to 90F in there without it.