omg, is this for real? weird how recent conspiracy rumbling about gvmnt taking away gas stoves may have been covering for a real conspiracy. First I’ve read about benzene in stove fumes. Like cooking w/gas

  • Semi-Hemi-Demigod
    link
    fedilink
    6
    edit-2
    11 months ago

    I have a cheap induction hot plate and while it boils water extremely fast it still burns things on low heat because it’s just cycling max power on and off at set intervals. I don’t like it for anything that needs long, low, and slow cooking because it will burn it

    • @[email protected]
      link
      fedilink
      411 months ago

      That’s true with any electric heater element. It’s called pulse width modulation (PWM) and is actually very effective when done properly. Seems like the frequency is too long on yours. It should be cycling many times per second, meaning the full power is only on for milliseconds at a time, nowhere near enough to actually burn things.

      Even a cheap Arduino is capable of PWM at 16MHz (16 million duty cycles per second; we’re talking microseconds here now). So I’d think even a cheap one should have good PWM control, but I guess you get what you pay for.

      • @tburkhol
        link
        411 months ago

        I don’t know about proper induction cooktops, but the hot plates all seem to use mechanical relays to switch power, so they’re limited to far less than 16 MHz. Most seem to use regular, industrial controls that operate at more like 1-0.1 Hz.

        I honestly don’t think you’d want to use anything but a mechanical relay to switch 10-15 amps. Do that with a solid state relay, and you’re going to waste 15-25 W in a small package that will have to be radiated somewhere.

      • Semi-Hemi-Demigod
        link
        fedilink
        211 months ago

        I read a bunch of reviews from reputable sites and bought what they said was the best. Apparently they couldn’t even spring for an Arduino because the pulse widths are seconds long.

        • @[email protected]
          link
          fedilink
          111 months ago

          It’s not the logic that’s expensive, it’s the solid state relay suitable for high power, high frequency switching

          • @[email protected]
            link
            fedilink
            111 months ago

            By “expensive” we’re still only talking a dollar or two. It’s not going to spike their cost to the point where it would be prohibitive to them.

          • Semi-Hemi-Demigod
            link
            fedilink
            111 months ago

            I don’t need MHz switching. A few kHz would be better than just turning it on for 1 second out of 10 for “low power.”