So just something that’s been on my mind. At my workplace there’s an automatic road barrier that lifts up and down when vehicles arrive. However, it’s not used for a carpark system when people wave their tickets or something. It just goes up and down when a vehicle shows up.

However, it sometimes goes up for when say a pushcart is being rolled over whereas it wouldn’t for a guy pushing a bin.

So tldr, how does an automatic road barrier decide that yes, a vehicle is coming, and therefore opens up?

  • @[email protected]
    link
    fedilink
    461 year ago

    Same as traffic lights. “Inductive-loop traffic detectors use an electrically conducting loop embedded in the pavement to send a signal to the traffic control system to indicate the presence of a vehicle.”

    • Otter
      link
      fedilink
      English
      461 year ago

      So a large wooden horse could slip by without detection

      • astraeus
        link
        fedilink
        161 year ago

        If the large wooden horse is full of men in metal armor, purely hypothetically speaking, would the loop still not pick up the large wooden horse?

        • wkk
          link
          81 year ago

          Technically speaking it would pick up the men in metal armors, not the wooden horse per se.

          But the barrier would lift for the wooden horse full of men in armor indeed.

          • _haha_oh_wow_
            link
            fedilink
            English
            41 year ago

            Depends on how high on their horse they are: They might be too far away to trigger the sensor.

    • @[email protected]
      link
      fedilink
      19
      edit-2
      1 year ago

      This, it’s like a metal detector but, bigger. Temporary boom gates might use infrared motion sensors like automatic lights. edit: “lights” like the lights some people have on their porch.

      • TWeaK
        link
        fedilink
        English
        51 year ago

        It’s bigger in overall structure size, but isn’t really that big itself. It’s just a wire loop, they can be installed into existing roads with minimal effort - they just dig a narrow trench and then seal it up, it doesn’t require more tarmac.

    • @[email protected]OP
      link
      fedilink
      41 year ago

      Huh, so that’s a completely new concept I’ve learned today. Time to do more reading. Thanks!

      • @Tomahtoes
        link
        41 year ago

        Check the road in front of the gate. Those loops are usually installed after the asphalt so there should be a loop patched up with tar a bit smaller than a footprint of an average car.