Does this hobby ever get easier or is it always like getting kicked in the nuts by Ronaldo?

Filament some how leaked up and burned on. I just don’t have it in me to keep tinkering. I just want to print

    • @prime_number_314159
      link
      English
      131 year ago

      It’s worth noting that some but not all combinations of heat break, nozzle, and heater block require re-tightening at the temperature used for printing. Basically, different metals expand different amounts when they’re heated, so if the block expands more than the other two, a gap will open up between them, and melted filament can find its way through.

      • @Koopa_KhanOP
        link
        English
        71 year ago

        Good to know. I’ll add that to a check list to go through every now and again

      • Thanks4Nothing
        link
        fedilink
        English
        31 year ago

        Yes and on some printers, that spot where the Bowden tube meets the nozzle is very problematic. You have to loosen the nozzle a bit, push the Bowden tub up against it, then tighten the nozzle the rest of the way

        It was awful on my Ender clone, but haven’t had that issue on my Prusa.