Hey all, I just finished a run of Popandsicle’s excellent vase mode ornaments and I noticed these weird bulges happening all over the prints. The last run in a different color was flawless so I’m not sure where to start. I couldn’t find much on the issue with a bit of googling so I thought I’d check with you folks and see if you all had any insight.
I’ve calibrated my esteps and adjusted the resolution to be a bit easier on my printer (modified CR-10v2), and unfortunately my mainboard isn’t capable of linear advance.
Filament is overture royal gold, layer width is 0.6, height is 0.2.
I appreciate the help!
This is consistent across runs in the exact same spots.
I think it’s either mechanical on your y axis hardware or you’ve got a corrupted slicer file somehow. are you converting these differently than other prints in the past?
I didn’t do anything different slicer-wise, but I resliced the file with a higher temp and that seemed to solve the issue.
Then I checked the x gantry and found a ~2mm variance so I had to do that for the first time and now everything seems to be running great now lol.
Nice catch. I thought it was probably mechanical.